No
t f
or
co
m
m
er
cia
l u
se
Guidelines for Safe and Efficient Use
Some menus/features are operator dependent.
3
in the U.S. requires that some manufacturers’ accessories
shall be tested, and Sony Ericsson has done so with
respect to its products. To avoid causing loss of
performance or radio frequency exposure levels above the
permissible limits it is recommended that you only use
Sony Ericsson or Ericsson original accessories intended
for use with the mobile phone. If you wear the mobile
phone on your body while it is transmitting, and you do
not use a Sony Ericsson or Ericsson original body worn
accessory, please ensure that the mobile phone is
positioned a minimum of 1.5 cm from your body and
that you are not using an accessory that contains any
metal.
A separate leaflet with SAR information for this mobile
phone model is included with the material that comes
with this mobile phone. This information can also be
found, together with more information on radio
frequency exposure and SAR, on:
www.SonyEricsson.com.
Electronic Devices
Most modern electronic equipment is shielded from RF
signals. However, certain electronic equipment may not
be shielded against the RF signals from your mobile
phone, therefore:
Pacemakers
The Health Industry Manufacturers Association
recommends that a minimum separation of six (6”)
inches (15 cm) be maintained between a handheld
wireless phone and a pacemaker to avoid potential
interference with the pacemaker. These
recommendations are consistent with the independent
research by and recommendations of Wireless
Technology Research.
Persons with pacemakers:
•
Should ALWAYS keep the phone more than six
inches from their pacemaker when the phone is
turned ON;
•
Should not carry the phone in a breast pocket;
•
Should use the ear opposite the pacemaker to
minimize the potential for interference.
•
If you have any reason to suspect that interference
is taking place, turn your phone OFF immediately.
Summary of Contents for T61c
Page 1: ...Mobile Phone T61c...
Page 7: ...Not for commercial use...