Sonotec 200 08 0001, Operating Manual

Page: 16 / 30

SONOFLOW IL.52 V2.0 Operating Manual
2 Safety regulations
8
Revision: 1.0; Date: 2018-10-26
2.2 General safety information
The SONOFLOW IL.52 V2.0 is a state of the art product that complies with all applicable safety
regulations. All sensors are factory tested and delivered in a safe condition for operation.
The following safety instructions apply:
Incorrect installation and use of the SONOFLOW IL.52 V2.0 sensor and its
components can present a hazard for the user.

Installation may only be performed by qualified personnel. The
applicable planning and installation regulations must be followed. The
plant operator is responsible for the legal compliance of the installation
and documentation.

All listed conditions in the Technical Data Sheet
– especially regarding
temperatures and voltage range
– must be met unconditionally. Values
are not allowed to exceed or to fall below the specified limits, not even
temporarily.

The sensor may only be exposed to a minimal risk of mechanical
damage. In case of higher risks, the sensor must be protected against
mechanical influences.

If there is visible damage, the sensor must be taken out of operation
immediately.

The Sensor may not be immersed.

The use of cleaning agents depends on the sensor version (seals and
their resistance). Make sure, that the seals made of FFKM or Viton are
not damaged. Follow the instructions in chapter 6.2.

The sensor must never be opened. This impairs the product safety.
The sensor does not contain any user-serviceable parts. Repairs must
be carried out by the manufacturer.

Settings and parameters of the sensor can be changed with the
SONOFLOW Monitor. Make sure to read the corresponding document.
Never change settings before you have saved the default settings.