42 |
EN
8. Operation
Event
Play back saved settings
Play back saved settings
again
Trigger
Program start is only possible when
ultrasound is switched off.
Press "
PRE
SET
" briefly
Press "
PRE
SET
" briefly again.
If the program was previously aborted, the program
starts again from the beginning
(keyword: no interruption of the program but an abort
of the program).
Response
PRE
SET
LED lights
All previously set values are indicated by the corresponding LEDs.
If required: Heater on
Ultrasound starts automatically when the setpoint temperature is
reached.
The Start/Stop LED [1Hz] flashes in heating mode when the setpoint
temperature has not yet been reached.
Ultrasound is switched on every minute for 5 seconds during heating
up (mixing).
The Start / Stop Ultrasound LED also always lights when the ultra-
sound is active
The Programming LED [1 Hz] flashes after the end of the program
ACTUAL temperature is represented by flashing
Remaining runtime is represented by flashing.
Rotary controller, Degas / Boost button, Start / Stop Ultrasound button
and Programming
button are inactive during the program
Machine On/Off button is active for possible program abort.
All previously set setpoint values are indicated by the corresponding
LEDs.
If required: Heater on
Ultrasound starts automatically when the setpoint temperature is
reached.
The LED [1 Hz] flashes after the end of the program
ACTUAL temperature is represented by flashing
Remaining runtime is represented by flashing.
Rotary controller, Degas / Boost button are inactive during the program
SONOSWISS_GebrauchsanleitungD-E-FR-IT-ES_ARIAL_P.indd 42
16.10.18 08:02
