Install Tempo Ultra ATA66
1.
Select an available PCI slot to install the Tempo
and remove its access port cover
(Figure 10)
.
2.
Remove the Tempo from the anti-static
package, making sure to handle the board by
the edges.
3.
Align the Tempo over the PCI slot
(Figure 11)
. Gently press down until it is
firmly seated in the PCI slot, taking care not
to wiggle the board as you install it into
the slot.
4.
Attach the host connector on the Ultra ATA66
cable to the connector closest to the bracket on
the Tempo
(Figure 12)
; if you are unfamiliar
with the Ultra ATA66 cable connectors, see
page ix, for further information.
Close Computer
1.
Carefully position the Ultra ATA66 cable inside
the computer as to avoid crimping it by the
case cover and replace the side panel onto
your Power Macintosh
(Figure 13)
.
2.
Return the computer to your computing area
and reconnect the power and peripheral cables
to the computer.
Turn On Computer
1.
Turn on your Power Macintosh.
2.
For your computer to properly recognize a
new hard drive, you will need to initialize
and format it. Refer to Chapter 3, “Hard
Drive Initializing” for further instructions.
6-5
Figure 10
Figure 11
Figure 12
Figure 13
access port cover
Tempo
Ultra ATA66 cable
