Sonnenkonig 60001012, Manual

Page: 47 / 72

EN
47
Disconnect the appliance from the mains before cleaning or servicing it.
Do not use electrical appliances on the shelves of your unit unless recommended by the
manufacturer of your refrigerator.
Do not place heat radiating appliances on top of your unit.
Do not install the appliance in a place where it may come into contact with water/rain. Ot-
herwise, the insulation of the electrical system will be damaged.
Do not place a kettle or vases on your device. The electrical components of your device can
be seriously damaged by boiling water or spilled water.
Do not use steam cleaners to clean or defrost the unit. The steam may come in contact with
the electrical parts and cause an electrical short. RISK OF ELECTRIC SHOCK!
Never use mechanical devices, knives or other sharp-edged objects to remove encrusted ice
in the unit. RISK OF ELECTRICAL SHOCK due to damage to the inside of the unit.
Never allow children to play with the unit.
If you take the device out of operation (even temporarily), make sure that children cannot get
into the device. Strictly observe the corresponding safety instructions.
Strictly follow the instructions in the INSTALLATION chapter.
The condenser and compressor, located at the rear of the unit, can reach high temperatures
during normal operation. Carry out the installation according to this manual. Insufficient
ventilation of the unit will affect operation and damage the unit. Do not cover or block the
ventilation fins at any time.
Do not touch the extremely cooled surfaces with wet or damp hands, as your skin may stick
to these surfaces.
When moving the unit, hold it by the base and lift it carefully. Keep the device in an upright
position.
Do not tilt the device more than 45°.
If the unit is transported in a horizontal position, some oil from the compressor may flow into
the refrigerant circuit.
Allow the unit to stand upright for 4-6 hours before turning it on to ensure that the oil has
flowed back into the compressor.
Never use the door to move the unit as you will damage the hinges.
When unpacking the appliance, be aware of the location of each piece of internal equipment
in case you need to repack and transport it at a later time.
Do not operate the appliance unless all components are properly installed.
Do not stand or lean on the appliance‘s base, drawers, doors, etc.
Do not put hot liquids or hot food into the appliance.
The ventilation openings of the unit or its built-in structure (if the unit is suitable for instal-
lation) must be completely open, unobstructed and free of any kind of dirt.
03 - INSTALLATION
• Carefully unpack the device. Dispose of the packaging as described.
• The accessories of your device can be protected from transport damage (adhesive tapes, etc.). Re-
move such tapes very carefully. Remove residues of such tapes with a damp cloth with lukewarm
water and a mild detergent (see also chapter CLEANING AND MAINTENANCE). Never remove com-
ponents from the back of the unit.