Sonnenkonig 60001012, Manual

Page: 48 / 72

EN
48
04 - CONTROLS
• Install the device in a suitable position with sufficient distance to heat and cold sources.
• Make sure that the device and the power cable are not damaged.
• Install the device in a dry and well-ventilated place.
• Protect the device from direct sunlight.
• It must be possible to open the doors fully and unhindered.
• Install the device on a level, dry and solid floor. Check the correct installation with a spirit level.
• Connect the unit properly to the mains.
• The type plate is located inside the device or on the back.
• Allow the device to stand in an upright position for 4-6 hours before connecting it to the mains.
• Clean the device thoroughly. Be very careful especially inside the device (for more information see
the chapter CLEANING AND MAINTENANCE).
• If the accessories inside the device are not mounted in the correct position, replace them according
to the picture in chapter CLEANING AND MAINTENANCE.
• The unit must be properly connected to the power supply.
• Allow the unit to stabilize the temperature for about 24 hrs.
• Do not overfill the unit.
1. Activated carbon filter
2. Light
3. Fan
4. Temperature sensor
5. Shelf
6. Feet
7. Compressor holder
8. Door hinge
9. Door hinges
10. Central spindle
11. Shelf rail
12. Shelf
13. Door frame
14. Door seal
15. Door glass
16. Set temperature
17. Light switch
18. Temperature display
19. Temperature selection C°/
F°