Page 52
Replacing a Single Hard Drive
4.
Pop open the drive handle on the new hard drive by
pressing the square button.
5.
Insert the drive into the empty slot, label side up with the
handle sticking out.
6.
Press the drive firmly into place to seat the connectors, and
then close the handle.
7.
As the
System > RAID
screen refreshes (every 30
seconds), you will see the status change to
REBUILD-PAUSED
.
The status changes to
REBUILDING
within a few minutes.
8.
You may continue to use your SonicWALL CDP appliance
while the RAID controller rebuilds the array with the new
drive.
The rebuilding process requires at least six hours and
could take several times longer, depending on the amount
of data contained in the array.
Warning:
There is a noticeable performance degradation of
the RAID array while it is being rebuilt.
When finished rebuilding, the drive LED changes to green
and the status for the array changes to
OK
.
9.
Re-install the front bezel, being sure to properly line up the
LCD connectors.
The best practice is to align and seat the right side of the
bezel (as you are facing the front of the SonicWALL CDP
appliance), then view the connectors from above as you
carefully press the left side of the bezel into place.
10. Lock the bezel with the front bezel security key.
Summary of Contents for CDP 6080
