48
AeroVee 2.1
Rev Z. 01/14/2015
Sonex Aircraft
LLC
© 2014 All Rights Reserved
STARTER INSTALLATION / WIRING
Tools Required:
__ 3/8" Hex Wrench
__ Locktite 262
Parts Required
__ Starter, ACV-A01-16
__ ACV-Z01-14 Cap Screws
__ Electrical Terminals (not supplied)
__ Electrical Wire (not supplied)
Starter Wiring
The drawing below illustrates a typical starter wiring sche-
matic. This can be modified to suit your needs. Note that a
separate starter solenoid is not needed as the AeroVee starter
has a built-in solenoid.
STARTER WIRING SCHEMATIC
Starter Installation
Note: Though the starter is grounded through the bolts which
secure it to the accessory plate, anodizing in the threads of
the accessory plate and the recommended use of Locktite can
degrade this ground path. You may wish to install an 8 to
10 gauge supplemental ground wire under one of the starter
attachment bolts and attach the other end to an appropriate
ground on the airframe or battery.
do not use an engine mount bolt for a grounding point as
they are insulated from the engine by the rubber engine
mounts and do not provide a good ground path.
__ 1. Attach the starter to the accessory plate using two (2)
ACV-Z01-14 cap screws and Locktite 262.
The starter has two points
for electrical connections:
A large threaded lug (A) for
the 6 gauge starter wire, and
a small male spade terminal
(B) for the 14 gauge solenoid
wire.
A
B
Electrical connectors on the
starter solenoid.
When installing the starter, consider attaching an 8 gauge
ground wire under one of the starter mounting bolts and con-
necting the other end to the negative terminal of the battery.
