Sonance Navigator K2, Manual

Page: 58 / 106

Navigator K2 keypad
50
SYNC
This tab is used to configure the K2’s keypad synchronization feature. This
feature allows up to 10 keypads to be wired together so they track changes that
occur on any keypad in the group. To implement this feature all keypads in the
sync group must have their GND and KEYPAD SYNC pins tied together, and
each keypad should have the
Enable Keypad Syncing
box checked.
An idle keypad in the sync group will track event changes made to an active
keypad in the group only if the
Event
is enabled on the idle keypad and the
Channel
number matches that of the active keypad. For each event the channel
number can be set from 1 to 8. The channel number normally doesn’t need to be
changed from the default setting of 1, but it can be for unique situations.
Example: Four keypads (Keypad 1, Keypad 2, Keypad 3, and Keypad 4) are
wired together and you want them to behave as follows:
•
All of them should track each other’s Page Changes, Frame Changes, and
Scrolling List Position Changes.
• Keypad 1 and Keypad 2 should only track each other’s Relay Status
Changes.
•
Keypad 3 and Keypad 4 should only track each other’s Relay Status
Changes.
•
None of them should track Manual Power LED Changes.
Each keypad’s Sync settings should be configured as follows: