12
will appear on your mobile telephone. Before the first charge, loosen or
remove the back cover of the battery holder, after unscrewing the 3+2
screws. Pull out the sealing strip if one was installed on the battery. Put
back the middle section of the back cover. Connect the microUSB charging
cable, then turn the device on by holding the bell button down for approx.
5 seconds. The mains charger is not included, the use of e.g. SA 24USB,
SA 50USB chargers is recommended. Charge it for 4-5 hours before the
first use. At the end of its lifecycle, the battery can be replaced. You can
find replacements at speciality retailers. The polarity to be observed is
indicated inside the battery holder.
● ATTENTION! EXPLOSION HAZARD IF THE BATTERY IS NOT
REPLACED CORRECTLY! CAN ONLY BE REPLACED WITH AN
IDENTICAL MODEL OR A SUITABLE REPLACEMENT. DO NOT
EXPOSE THE BATTERY TO DIRECT HEAT OR SUN RADIATION
AND DO NOT THROW IT INTO FIRE! IF ANY FLUIDS HAVE LEAKED
FROM THE BATTERIES, CLEAN THE BATTERY COMPARTMENT
WITH A DRY CLOTH WEARING PROTECTIVE GLOVES.
Keep the BATTERY AWAY FROM CHILDREN. NEVER OPEN
UP, THROW INTO FIRE, OR SHORT CIRCUIT THE BATTERY.
EXPLOSION HAZARD!
● At the end of the lifecycle of the product, the battery has to be removed
and disposed of independently of the device, in accordance with the
local regulations.
SETUP AND OPERATION
The device automatically turns on when a visitor arrives (when it detects
movement). Depending on the settings, it can take a photograph of the
visitor and the blue light of the button, which activates when movement
is detected, shows that it can be pressed. After this, the wireless bell
located inside the apartment will ring and the mobile telephone will show
a notification.
The exterior unit is ready for operation if its battery has been charged or it
is connected to an external power supply via a cable. The device can be
turned on or off by holding the bell button for approx. 4-5 seconds. Later,