11
TWO POWER SUPPLY OPTIONS
The device is equipped with a built-in replaceable battery. This allows it to
be used in places where there is no mains power available at the fence or
gate. For example in weekend houses, resorts, or rented properties, where
a mains connection cannot be implemented. It is also useful if you only
need the device temporarily, for a shorter period of time. It can be used as
wireless CCTV as well, since it can be placed anywhere. If necessary, it
can be moved somewhere else within seconds.
In addition, if it is possible to use a mains supply cable, the device can be
operated using a mains adapter (AC/DC 12-24V/1A, not included) as well.
The wires found inside the wall mounter can be used for this purpose. (red:
+, black: -) In this case, it is not necessary to keep the battery charged.
(optional: e.g. NA 12P100 adapter, connected by a professional)
BUILT-IN BATTERY
The built-in battery provides approx. 3 months of continuous operation
on a full charge. This was measured with two half-minute conversations
per day at room temperature. The length of time the device can run on a
single charge can be extended if the motion detector is turned off (PIR)
and the Offline notification option is disabled. If possible, avoid continuous
motion in front of the device as it uses a multi-step energy saving mode.
It only switches to the most energy efficient ‘sleep’ mode after a longer
period of no movement. The current charge level can be checked using the
application. To protect the longevity of the battery, it is not recommended
to let it go below 20-30%. Since capacity is reduced in the cold, it is
recommended to charge it before the winter and pay increased attention to
the charge level in order to ensure continuous operation. The application
can send a notification well before the device runs out of charge.
To charge the device, lift it out of the wall holder after removing the screw
found on the bottom. Clean it using a clean wipe. The charger (5V/2A,
not included) has to be connected to the microUSB port located under
the rubber cover on the side of the device. The full charging process
takes about 5 hours, which is sufficient for 3 months of operation. During
charging, keep the device turn on. After charging is complete, a notification