Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language.
This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or
lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or
have been given instruction concerning use of the appliance by a person responsible for their safety and
they have understood the hazards associated with use.
Children should not be allowed to play with the
unit.
Children may only clean or perform user maintenance on the appliance under supervision.
WARNINGS
•
Confirm that the appliance has not been damaged during transit!
•
Only for indoor use!
•
Keep the
appliance away from heating and other electrical appliances!
•
Connect only to 230 V~ / 50 Hz voltage
power sockets!
•
Unwind the power cable completely!
•
Never connect the appliance to electrical network
with wet hands!
•
Do not lead the power cable on the appliance!
•
Do not lead the power cable under
carpets, doormats, etc.!
•
The appliance should be located so as to allow easy access and removal of the
power plug!
•
Lead the power cable so as to prevent it from being pulled out accidentally or tripped over!
•
If
the power cable is damaged, disconnect the appliance immediately and contact a specialist!
•
When
cleaning, filling the water tank, replacing the appliance or other maintenance, disconnect the appliance by
unplugging the connection plug.
•
Never touch the water and the parts of the appliance in the water when
the appliance is under power.
•
Never operate the appliance without water.
•
Do not scratch the oscillator!
•
Do not immerse the appliance in water, the pieces under voltage cannot get in touch with water!
•
Do not
operate unattended in the presence of children!
•
Do not let children play with the unit!
•
Never disassemble
the appliance.
•
When not planning to use the unit for an extended period of time, switch it off then remove
the power plug from the outlet and empty the water tank.
•
If any irregular operation is detected (e.g.,
unusual noise or burnt odor from unit), immediately switch it off and remove the power plug!
•
The unit is
intended for household use. No industrial use is permitted!
u
ltrasonic cold humidifier
UHP 4000
EN
In the event that the power cable should become damaged, it should only be replaced by the
manufacturer, its service facility or similarly qualified personnel.
Caution: Risk of electric shock!
Do not attempt to disassemble of modify the unit or its accessories.
In case any part is damaged, immediately power off the unit and seek the assistance of a specialist.
FEATURES
Ultrasonic cold humidifier
•
touch button control
•
water tank capacity: 4 l
•
adjustable humidification in 3 stages, different color
2
indicator light
•
humidifying: max. 250 ml/hour
•
recommended room size: max. 40 m
•
water tank
access window
•
in case of water shortage, it turns off
PARTS OF THE DEVICE
Figure 1.
1.
vapor nozzle
•
2.
removable cover
•
3.
water tank handle
•
4.
water tank
•
5.
water tank cup, with valve
•
6.
oscillator
•
7.
evaporator appliance
•
8.
touch button with indicator lights
•
9.
air filter
•
10.
power cable
INSTALLATION
1.
Keep the appliance at room temperature for half an hour before switching on.
2.
Place the appliance on a firm, horizontal surface. The appliance suck in the air at the bottom, do not
let anything to block this. (e.g. loose table cloth)
3.
Remove the vapor nozzle with the removable cover. (1, 2)
4.
Remove the water tank (4) from the unit, unscrew the cap (5), fill the water tank with room
temperature water and then screw it back on.
5.
Check that the oscillator (6) is clean and then correctly reattach the water tank to the unit.
6.
Only connect the appliance to the mains after this.
FUNCTIONS
By touching the touch button you can select from three vapor
stages. The unit indicates the first,
lowest stage in pink, the middle stage in green, and the highest stage of vapor in blue.
During humidification, the moisture around the unit may condense on the table and the surrounding
objects. If you experience this, choose a lower stage of humidification. The vapor nozzle can be rotated
360° round to select the correct humidification direction.
If water is running out of the tank, the appliance stops, beeps three times, and the touch button lights
up in red. You will notice the same thing when you lift the appliance's water tank during operation.
On the bottom of the unit there is a removable, washable filter that filters the air sucked into the
device.
FILLING THE WATER TANK
Attention! Before filling the water tank, power off the appliance by unplugging the connection plug.
Fill the water tank in accordance with points 3-5 of the Installation section.
Excessive cold or hot water will block the formation of vapor and may damage the appliance.
EMPTYING THE WATER TANK
Attention! Before emptying the water tank, power off the appliance by unplugging the connection plug.
Lift the tank out of the appliance, unscrew the cap from it, and pour out the water. Carefully lift the
appliance up and pour the water out of it, too.
After assembling the appliance, keep it in anhydrous condition in a cool, dry place.
CLEANING
If hard water is used, over time limescale will be deposited in the water tank and in the parts in contact
with the water. The limescale deposited on the oscillator inhibits normal operation.
We recommend that
1. Use distilled water.
2. Clean the water tank and oscillator weekly.
3. Frequently change the water.
4. If it is not used for a long time, clean the entire appliance and store it dry.
Cleaning the water tank, descaling
1.
Turn off the humidifier, then disconnect the power supply by unplugging the connection plug.
2.
Rinse the water tank with slightly vinegary water (1 tablespoon of vinegar in 1 glass of water), than
with clean water as well.
Cleaning the oscillator, descaling
1.
Turn off the humidifier, then disconnect the power supply by unplugging the connection plug.
2.
Lift the water tank out of the appliance and pour the water out of the oscillator.
3.
Drip 5-10 drops of vinegar into the oscillator, wait 2-5 minutes.
4.
Clean the surface of the oscillator
with properly soft material, e.g.
cotton swab
.
5.
Rinse with clean water.
Cleaning the filter
1.
Turn off the humidifier, then disconnect the power supply by unplugging the connection plug.
2.
Lift the water tank out of the appliance and pour the water out of the oscillator.
3.
Remove the grid at the bottom of the machine and wash the filter in tap water.
4.
Replace the grid after the filter has dried.
5.
Reinstall the device.
TROUBLESHOOTING
SPECIFICATIONS
Power supply: . . . . . . . . . . . . . . 230 V~ / 50 Hz
Output: . . . . . . . . . . . . . . . . . . . 30 W
Length of power cable: . . . . . . . . 1,55 m
Dimensions of water tank: . . . . . . 4 liter
Humidification: . . . . . . . . . . . . . . max 250 ml / hour
Ambient temperature:. . . . . . . . . 5-40 °C
Noise level: . . . . . . . . . . . . . . . . 35 dB(A)
Dimensions:. . . . . . . . . . . . . . . . 237 x 128 x 344 mm
Malfunction
humidifying does not work
all settings are correct, but the vapor
does not come out of the device
Solution
fill distilled water
to the water tank
adjust the water tank on the appliance
check the power supply
clean the oscillator
