5
22. Always remove power from the heater before relocating it.
23. The appliance should only be moved by handling it from its sides no earlier than 15 minutes after it has
been switched off.
24. If any irregular operation is detected (e.g., unusual noise or burnt odor from unit), immediately switch it off
and remove the power plug.
25. Make sure that no foreign objects or liquid can enter the unit through the openings.
26. Protect from dust, humidity, sunlight and direct heat radiation.
27. Power off the unit by unplugging it from the electric outlet prior to cleaning.
28. Do not touch the unit or the power cable with wet hands.
29. The appliance may only be connected to properly grounded 230 V~ / 50 Hz electric wall outlets.
30. Unwind the power cable completely.
31. Lead the power cable on the floor, avoiding the radiating heat from the unit.
32. Do not lead the power cable under carpets, doormats, etc.
33. Do not use extension cords or power strips to connect the unit.
34. The appliance should be located so as to allow easy access and removal of the power plug.
35. Lead the power cable so as to prevent it from being pulled out accidentally or tripped over.
36. The unit is intended for household use. No industrial use is permitted.
37. Due to continuous improvements, the technical data and design may change without any prior notice.
38. The actual instruction manual can be downloaded from www.somogyi.hu website.
39. We don’t take the responsibility for printing errors which may occur, and apologize for them.
CAUTION: RISK OF ELECTRIC SHOCK!
Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged,
immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer,
its service facility or similarly qualified personnel.
DO NOT COVER!
COVERING THE UNIT CAN CAUSE OVERHEATING, FIRE OR ELECTRIC SHOCK.
INSTALLATION
1. Before installation, carefully remove packaging, and make sure not to damage the unit or the connecting
cable. If you find any damage, the unit must not be operated!
2. It is STRICTLY PROHIBITED to install or use the appliance in zones 0 and 1 of premises containing
bathtubs or showers
(see Figure 4)
!
3. All circuits in premises containing bathtubs or showers shall be protected with one or more RCDs with a
rated triggering current of up to 30 mA!
4. Take out the unit from the box. Fasten the enclosed feet to the bottom of the heater using the bolts.
(Figure 3)
5. Place the unit on its feet on a hard, flat surface.
6. To ensure proper operation, you have to arrange for the free circulation of hot air. Therefore, please,
observe the minimum clearances indicated in
Figure 2
.
7. The switches on the unit must be in OFF position!
8. Plug the unit into a standard grounded wall socket. Now the unit is ready for operation!
CLEANING & MAINTENANCE
In order to ensure optimum functioning, the unit may require cleaning at least once a month, depending on the
manner of use and degree of contamination.
1. Switch off and power off the unit by unplugging it from the electric outlet prior to cleaning.
2. Allow the appliance to cool (for at least 30 minutes).
