EN
Tilt Only 50 WF RTS Central
7
Copyright
©
2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.3.4. Programming the RTS control point
The drive is in programming mode:
Briefly press the
PROG
button on the RTS control
point to be programmed:
The motorised product moves up and down:
this RTS control point is programmed in the drive and the green LED flashes five
times.
!
If the drive is no longer in programming mode, repeat step
2.3.1. Pre-
programming the RTS control point
before performing step
2.3.4.
Programming the RTS control point
.
2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2.4.1. Questions about the drive ?
Observations
Possible causes
Solutions
The motorised
product does
not work.
There may be some radio
interference.
Disconnect the power supply
cable, then reconnect the
battery to the drive.
One or more batteries are
installed the wrong way.
Check that the batteries are all
installed correctly.
One or more batteries are
leaking in the battery housing
tube.
Replace all the batteries.
The batteries (in the battery
tube) are low.
Check the battery power
levels and replace if
necessary.
The control point battery is
low.
Check the battery power level
and replace if necessary.
The control point is not
compatible.
Check for compatibility and
replace the control point if
necessary.
The control point used has
not been programmed into
the drive.
Use a programmed control
point or program this control
point.
PROG.
5148543A000_Tilt-Only-50-WF-RTS-Central_EN_SL.pdf 7
5148543A000_Tilt-Only-50-WF-RTS-Central_EN_SL.pdf 7
13/02/2019 11:50
13/02/2019 11:50
