EN
Tilt Only 50 WF RTS Central
6
Copyright
©
2019 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.3.2. Checking the direction of rotation
Press the
Up
button on the RTS control point:
a) If the slats tilt in the desired direction, the
direction of rotation is correct: go to section
2.3.3. Setting the end limits
.
b) Otherwise: move onto the next step.
•
b1) Press the
my
button of the RTS control
point until the motorised product moves up
and down. The direction of rotation has been
modified.
•
b2) Press the
Up
button on the RTS control
point to check the direction of rotation.
2.3.3. Setting the end limits
!
The end limits can be set in any order.
Attention
Do not set an end limit in a position capable of li
!
ing the motorised
product as this could damage the motorised product and/or the
motor in the long term.
1) Place the motorised product in the desired
lower position by pressing the
Down
button.
2) Press the
my
and
Up
buttons simultaneously
until the motorised product moves. The lower
end limit is now memorised and the green LED
flashes five times.
3) Press the
my
button when the motorised
product reaches the desired upper position. If
necessary, adjust the position of the motorised
product using the
Up
and
Down.
4) Press the
my
and
Down
buttons simultaneously
until the motorised product moves. The upper
end limit is now memorised and the green
LED flashes five times.The motorised product
moves down and will stop at its lower end limit.
5) To confirm the end limit settings, press the
my
button until the motorised
product moves up and down. The end limits have been programmed.
a
b
=
=
b1
b2
1
3
5
2
4
5148543A000_Tilt-Only-50-WF-RTS-Central_EN_SL.pdf 6
5148543A000_Tilt-Only-50-WF-RTS-Central_EN_SL.pdf 6
13/02/2019 11:50
13/02/2019 11:50
