background image

Sunis Outdoor WireFree RTS Sun Sensor

Introduction

Part Number:
9020412

The Sunis Outdoor WireFree™  RTS Sun Sensor provides control of your RTS motorized 

awnings, pergolas, exterior screens and rolling shutters based on current sun light levels. 

The precise sun level can easily be selected with 8 possible levels of light sensitivity. 

Note: 

The sun function can be enabled/disabled via a Somfy Soliris RTS transmitter.

A transmitter must be provided with each installation to enable/disable the sun function.

Sensor Cover

Alignment

Arrows

Included:

 

A.

 Sunis RTS sensor with built 

     in mounting base

B.

 2 AA alkaline batteries

C.

 2 mounting screws

Programming

Button (PROG)

Inside Cover

Green LED

Level 5-8

Red LED

Level 1-4

+ Sun

Level

- Sun

Level

Red Battery

LED

Green Battery

LED

Battery

Tray

A.

C.

B.

Continued On Next Page

Summary of Contents for Sunis WireFree

Page 1: ... levels of light sensitivity Note The sun function can be enabled disabled via a Somfy Soliris RTS transmitter A transmitter must be provided with each installation to enable disable the sun function Sensor Cover Alignment Arrows Included A Sunis RTS sensor with built in mounting base B 2 AA alkaline batteries C 2 mounting screws Programming Button PROG Inside Cover Green LED Level 5 8 Red LED Lev...

Page 2: ...e and sensor cover Then open the sensor by lifting the sensor top from the mounting base Fig 1 2 Install the batteries paying attention to the polarity shown on the base Fig 2 Mounting Mounting the Sunis Outdoor Wirefree RTS Sun Sensor to an outside wall 1 First Drill two holes 17mm apart Fig 4 Remember to use the correct bit type for the wall material 2 Mount the Sunis Outdoor WireFree RTS Sun Se...

Page 3: ...ears all sensors Then repeat steps 1 and 2 normally to add the new sensor Programming Button PROG Back of RTS Transmitter Programming Button PROG Fig 6 Note A Soliris transmitter must be programmed to the awning pergola exterior screen or rolling shutter to allow the user to Enable Disable the sun function If a sensor is removed or damaged it must be cleared from the motor memory Setting Sun Thres...

Page 4: ...ference to radio television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures listed on somfy com Operation Demo Mode WARNING Changes or modifications not expressly approved by the manufacturer could void the user s authority to operate the equipment AS WITH ANY PRODUCT INVOLVING ...

Reviews: