background image

This device complies with Part 15 of the FCC Results. Operation is subject to the following two conditions:

1. The device may not cause harmful interference, and 2. This device must accept any interference received, including that which may cause undesired 

operation.

NOTE: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. 

These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. 

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio television reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures listed on somfy.com

Operation: Demo Mode

WARNING: Changes or modifications not 

expressly approved by the manufacturer could 

void the user’s authority to operate the equipment.

AS WITH ANY PRODUCT INVOLVING GENERATION OF ELECTRICAL POWER, CAUTION MUST BE USED AT ALL TIMES. 

PLEASE CAREFULLY READ AND FOLLOW ALL OF THE INSTRUCTIONS.

Note: Visit https://store.somfysystems.com/ to 

purchase an additional or replacement product. 

Demo Mode allows the Sunis Outdoor WireFree™ RTS Sun Sensor to be more easily tested by 

reducing the delay times.

 

 

1. Pressing the + & - together will cause the Sunis to cycle in or out of Demo Mode.

 

2. The Red and Green LEDs will alternate when entering Demo Mode and blink together when exiting. 

 

3. The Sunis will automatically time out of Demo Mode in 3 min.

Green 

LED

Red 

LED

Time Delays
Normal Mode
Demo Mode

No Sun
15-30 min
15 sec

Sun
2 min
10 sec

C-0060 02/2022

Summary of Contents for Sunis WireFree

Page 1: ... levels of light sensitivity Note The sun function can be enabled disabled via a Somfy Soliris RTS transmitter A transmitter must be provided with each installation to enable disable the sun function Sensor Cover Alignment Arrows Included A Sunis RTS sensor with built in mounting base B 2 AA alkaline batteries C 2 mounting screws Programming Button PROG Inside Cover Green LED Level 5 8 Red LED Lev...

Page 2: ...e and sensor cover Then open the sensor by lifting the sensor top from the mounting base Fig 1 2 Install the batteries paying attention to the polarity shown on the base Fig 2 Mounting Mounting the Sunis Outdoor Wirefree RTS Sun Sensor to an outside wall 1 First Drill two holes 17mm apart Fig 4 Remember to use the correct bit type for the wall material 2 Mount the Sunis Outdoor WireFree RTS Sun Se...

Page 3: ...ears all sensors Then repeat steps 1 and 2 normally to add the new sensor Programming Button PROG Back of RTS Transmitter Programming Button PROG Fig 6 Note A Soliris transmitter must be programmed to the awning pergola exterior screen or rolling shutter to allow the user to Enable Disable the sun function If a sensor is removed or damaged it must be cleared from the motor memory Setting Sun Thres...

Page 4: ...ference to radio television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures listed on somfy com Operation Demo Mode WARNING Changes or modifications not expressly approved by the manufacturer could void the user s authority to operate the equipment AS WITH ANY PRODUCT INVOLVING ...

Reviews: