Programming
Continued On Next Page
Pairing a Sunis Outdoor WireFree™ RTS Sun Sensor to
the Shading Solution
1. Press the programming button on the RTS transmitter
for 3+ sec until the window covering moves.
2. Press the Programming button on the Sunis. (Fig. 6)
The green Prog LED will light and the window covering will move.
The Sunis has been paired with the motor.
To delete/remove the sensor - Repeat steps 1 and 2 above.
To delete all sensors when adding a new sensor, follow
steps 1 and 2 above except on step 2 hold the prog
button until the covering moves twice. This clears all sensors.
Then, repeat steps 1 and 2 normally to add the new sensor.
Programming
Button (PROG)
Back of RTS
Transmitter
Programming
Button (PROG)
Fig. 6
Note:
A Soliris transmitter must be programmed to the awning, pergola, exterior screen
or rolling shutter to allow the user to Enable/Disable the sun function. If a sensor is
removed or damaged, it must be cleared from the motor memory.
Setting Sun Threshold Level
The Sun Threshold level can be adjusted up or down by a short press of the + or - button. For
levels 1 to 4 the Red LED will blink 1 to 4 times to confirm the level. For levels 5 to 8 the Green
LED will blink.
Thresholds
Sunlight
Intensity
(kLux)
LED active
Number of
Flashes
1
2
3
4
5
6
7
8
1
5 10 20 40 55 75 100
Red
Green
Increase
Threshold
Decrease
Threshold
