EN
Sonesse® 40 Zigbee
9
Copyright
©
2018 SOMFY ACTIVITES SA, Société Anonyme All rights reserved.
2. INSTALLATION
Warning
• These instructions are
mandatory for the drive and home automation professional installing
the drive.
• Comply with current standards and legislation in the country of installation.
Attention
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
• To ensure optimized silent operation, the gaps between the drive, the accessories, the tube
and the tube end piece must be minimized.
2.1. ASSEMBLY
2.1.1. Preparing the drive
Check that the inner diameter of the motorized product’s tube is
greater than 37 mm.
1) Fit the accessories required to integrate the drive into the
winding tube:
• Either fit the drive wheel
a on the drive.
• Or fit the crown
b and the drive wheel a on the drive.
2) Measure the length (
L) between the inner edge of the drive
head and the rim of the drive wheel.
2.1.2. Preparing the tube
1) Cut the winding tube to the required length, depending on the
motorised product.
2) Deburr the winding tube and remove the swarf.
3) For winding tubes which are smooth inside, cut a notch with
the following measurements: l = 7 mm, L = 10 mm.
2.1.3. Drive/tube assembly
1) Slide the drive into the winding tube.
For winding tubes with a smooth interior, position the cut
notch on the crown.
2) The drive wheel must be locked in place to prevent any
movement in the winding tube: This can be achieved by
fastening the winding tube to the drive wheel using 4 self-
tapping screws, Ø 5 mm, or 4 steel pop rivets, Ø 4.8 mm,
placed between 5 mm and 15 mm from the outer edge of the
drive wheel, regardless of the winding tube.
Attention
The screws or pop rivets must only be fastened onto the drive wheel and not on the drive.
L
L = …
Ø > 37
l L
2
L
L = …
Ø > 37
l L
1
bb
aa
L
L = …
Ø > 37
l L
L
L = …
Ø > 37
l L
1
2
L
L = …
Ø > 37
l L
3
L
L
1
2
