Fixing the devices
This detector makes it possible to detect the presence of any human in a room in the presence
of a small pet of a height less than 40 cm.
In the case of dogs taller than 40 cm, it is better to choose the movement detector for dwellings
with big dogs.
Movement
detector for
small pets
1
2
It should preferably be wall-
mounted at a height of between
2.10 and 2.40 m above the floor.
Do not lose the nut
in the
bag containing the screw kit.
Do not lose the nut
when opening the detector in order to change the
battery.
Do not close the detector again.
TEST mode is used to check the range of the detector.
The detector is positioned with its base on the wall but without being screwed on and
someone passes within the detector field.
Once the TEST has been successfully concluded,
it is essential to set jumper 3 to the OFF
position
in order to switch to operating mode.
In the case of medium-sized dogs, it is
better to mount the detector at a height of
2.40 m. Make sure that the detector is
mounted at least 80 cm above any piece of
furniture that a cat can climb on.
3
4
The detector has 3 jumpers:
Customising detector operation
2
1
1 Indicator light
2 Detection by
2 or 4 beams
3 TEST mode
ON
With indicator light on the
front in the event of
detection.
This will affect the
duration of detector
battery operation.
Detection by
2
beams
(most sensitive detection)
(the detector is supplied in
this mode).
Test mode: with indicator
light on each detection
(jumper 1 to ON).
OFF
Without indicator light in
the event of detection
(detector supplied in
this mode).
Detection by
4
beams.
Recommended if several
pets are present.
Normal operating mode.
3
Position the nut
in its housing and tighten
the locking screw.
Close the detector again. Tighten the screw at
the base of the detector.
2
D
EFAULT POSITION OF THE JUMPERS
1
3
■
14
■
