INSTALLING & SETTING UP YOUR POWERED ROLLER BLIND
Before installing your powered roller blind, check you have the following:
2 x Universal
Brackets
FITTING YOUR POWERED ROLLER BLIND
1 x Powered
Roller Blind
4 x screws
4 x raw plugs
STEP 1
Fitting your blind inside the window recess
• you have uPVC window frames
• the
re are obstructions like handles
Fitting your blind outside the window recess
Follow the measu
r
ement steps below to ensu
re that centre of
your powered r
oller blind is exactly in the middle of your window:
The measu
r
ements at either end of the
r
ecess (C) need to be
the same.
T
o work out C:
1)
Measur
e the width of the window (measu
r
ement B).
W
rite down the measu
r
ement.
2)
Measur
e the width of the blind (measu
r
ement A).
W
rite down the measu
r
ement.
3)
T
ake measu
r
ement B away f
r
om measu
r
ement A and
divide the answer by 2 to get measu
r
ement C.
STEP 2
Marking the bracket positions
Put the blind into the corresponding ends of the brackets as illustrated, then
illing.
Important note: Ensure that the plunger at the pin end (opposite the motor end) is
fully depressed when marking the hole positions. Also leave enough room to mount
the battery pack if you plan to secure it behind the blind.
STEP 3
Fitting the battery pack clips
Now that the bracket positions ar
e marked, you can secu
re the battery pack
clips in place at the same side as the motor position.
For inside r
ecess blind mounting, secu
re the clips in place behind where the
blind will be situated (as illustrated).
For outside r
ecess blind mounting, secu
re the clips in place behind and above
wher
e the blind will be situated (as illustrated).
A
B
C
C
1 x Battery Pack
2 x Battery Clips
Battery clip
mounting on an
inside recess
Battery clip
mounting on an
outside recess
Powered roller
blind system
Motor head
Bracket cover
1 x Remote or
Wall
Switch Cont
rol
Need help with your Power
ed Roller Blind? Call 0800 014 6123
or 0345 031 7897 from a mobile