FITTING YOUR POWERED ROLLER BLIND continued
STEP 4
Fitting the brackets and battery pack
Secure the brackets in place at the marks previously made.
If securing the brackets to plaster, brick, stone, etc., drill the holes at the marked positions using a 5.5mm
masonary drill bit and insert the raw plugs supplied. Fix the brackets in place using the screws supplied.
Important note: The pin end plunger must be fully depressed, otherwise it will lock in place and refuse to rotate.
STEP 5
Mounting the powered roller blind
Hold the blind to the brackets with the fabric hanging from the back of the blind and
idle end (opposite the motor head end) into position by locating the ‘+’ shaped plunger
into the ‘+’ shaped part of the bracket. When correctly aligned, the plunger should pop
into the bracket and secure in place.
Now angle the motor head side into position and slot the prongs of the motor head plate
into the bracket, ensuring that the central prong drops into position on the bracket.
STEP 6
Connect the battery pack to your powered roller blind
it with the long socket on the battery pack. Then connect the short plug into the
motor socket as indicated.
Important note: Your powered blind is powered up and tested to ensure it is operating correctly prior to
dispatch. During this process, the upper and lower stopping positions of your blind are preset based on your
height measurement. We also pair the control ordered to the motor for your convenience.
STEP 7
Test your powered roller blind
Press the down button on your control.
The blind will travel down for a few seconds, then reverse direction and
travel back up to the original starting position. This ‘Down/Up’ movement
occurs when the powered blind is operated after a battery pack is plugged back into the motor. This is a visual
feedback response from the motor to inform the user that power has been restored to the blind.
OPERATING YOUR POWERED ROLLER BLIND
Need help with your Powered Roller Blind? Call 0800 014 6123
or 0345 031 7897 from a mobile
Press the Down button on your
control to close the blind. The blind
will automatically stop at the lower
stopping position.
Press the Up button on your
control to open the blind. The blind
will automatically stop at the upper
stopping position.
Press the Stop button on your
control to stop the blind at any point
within the upper or lower stopping
positions.
