Copyright © 2009 Somfy SAS. All rights reserved.
Lighting Modulis RTS Ramp
38
Installation guide
EN
7.2.2 Group control
Group control: an RTS control point controls several Lighting Modulis RTS Ramp units.
1) Switch off the power supply to the Lighting Modulis RTS Ramp (C, D
and E) to be controlled by a single control point.
Switch on the power supply to the fi rst Lighting Modulis RTS Ramp
2)
(C) to be linked to the control point.
Simultaneously press the Up/Down buttons on the RTS control point:
3)
the ramp comes on then goes out.
Press the PROG button on the RTS control point: the ramp will come
4)
on then go out again to indicate that the RTS control point has been
programmed into the Lighting Modulis RTS Ramp.
Switch off the power supply to the newly linked Lighting Modulis RTS
-
Ramp before adding the next Lighting Modulis RTS Ramp.
Switch on the power supply to another Lighting Modulis RTS Ramp
-
to be linked and repeat steps 3) and 4)
Repeat the procedure for each of the other Lighting Modulis RTS
-
Ramp units to be controlled with this RTS control point.
Switch on the power supply to all the Lighting Modulis RTS Ramp
-
units linked to the RTS control point.
7.3 Setting the “my” favourite light intensity
N.B.: The favourite light intensity factory setting for the Lighting
Modulis RTS Ramp is 50% of the maximum intensity. This favourite
position may be modifi ed as required.
7.3.1 From a control point from the Modulis range
A control point from the Modulis range has a thumbwheel for
settings.
1) Press the my button to switch on the ramp to the preset favourite
position.
Move the thumbwheel to adjust the light intensity level as required.
2)
Once the required level of light intensity has been reached, press
3)
the my button until the ramp comes on then goes out:
The new favourite light intensity level has been programmed and
-
the ramp will come on at this level.
7.3.2 From a standard control point
A standard control point is a three button control point (Up/Stop-my/
Down).
1) Press the STOP/my button to switch on the ramp in the preset
favourite position.
Press and hold the up or down buttons to adjust the light intensity
2)
as required.
Once the required level of light intensity has been reached, press
3)
the STOP/my button until the ramp comes on then goes out:
The new favourite light intensity level has been programmed and
-
the ramp will come on at this level.
1
OFF
2
3
ON
4
C
a
PROG.
C
C
C
D
E
C
3
2
1
100%
+
-
0%
3
2
1
100%
+
-
0%
-
-
5061612X00_LMR_RTS_livre.indb 38
30/04/09 18:44:55
