JR RU 30 RTS LI-ION
EN
7
Copyright
©
2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2.4. TIPS AND ADVICE ON INSTALLATION
2.4.1. Questions about the drive?
Observations
Possible causes with visual
findings
Solutions
The driven product does
not operate.
Drive battery is low and requires
charge. Red LED blinks 5 times
when any button of a paired con-
trol point is pressed.
Charge the battery.
The control point battery is low.
Drive LED doesn't light when any
button of a paired control point is
pressed.
Check the battery and replace it
as required.
The control point is not compatible
or not programmed. Drive LED
doesn't light when any button of a
paired control point is pressed.
Check the compatibility and
replace the control point as
required.
An obstacle hinders the movement
of the driven product. The Red LED
lights fixed on.
Remove the obstacle.
Drive position is out of the end
limits. Red LED blinks 2 times inter-
mittently and continually.
Proceed to section «Setting the
end limits»
Motor is neither set nor paired. Or-
ange LED lights fixed on.
Proceed to section «Commis-
sioning»
The driven product stops
too soon.
The end limits are incorrectly
programmed/
Adjust the end limits.
The driven product has exceeded
recommended weight limit.
Replace driven product.
Battery is low. Red LED blinks 5
times when any button of a paired
control point is pressed.
Charge the battery.
The driven product moves
Up and Down 3 times
Setting is not allowed.
Red LED blinks 3 groups of 3 times.
Maximum or minimum value is
reached for the desired setting.
Or memory is full.
Red LED blinks slowly
for 3 seconds before and
after motor running.
Battery is low. Battery capacity is
less than or equal to 5%.
Charge the battery.
2.4.2. End limit readjustment
Attention
Control point must be paired to the driven product.
!
Orange LED blinks slowly until the new end limit is recorded.
2.4.2.1. Readjusting the upper end limit
1) Briefly press the UP button, to move the driven product to
the upper end limit.
2) Press and hold the UP and DOWN buttons simultaneously
until the driven product briefly moves Up and Down.
3) Press and hold the UP or DOWN button to move the driven
product to the new desired position.
4) To confirm the new position press and hold the MY button
until the driven product briefly moves Up and Down and
green LED blinks 5 times.
1
2
3
4
