EN
JR RU 30 RTS LI-ION
4
Copyright
©
2017 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
2. INSTALLATION
Attention
• These instructions are
mandatory
for the home motorisation and automation professional
installing the drive.
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
2.1. ASSEMBLY
2.1.1. Drive preparation
1) Fit the crown (a) and drive wheel (b) to the motor.
2) Measure the length (L) between the end of the drive wheel
and the head end.
2.1.2. Tube preparation
Check that the inner diameter of the tube is greater than 30 mm.
Cut the tube to the required length.
Deburr the tube and remove the debris.
2.1.3. Drive/tube assembly
1) Slide the drive into the tube. Insert the wheel by aligning the
wheel to the tube profile. Insert the drive half way and then
slide the crown down the drive and insert it in the tube. Fi-
nally, push the motor inside the tube.
2) Not required, but if needed, fix the tube to the drive with
self-tapping screws or steel pop rivets depending on the
dimension (L).
2.1.4. Mounting the tube-drive assembly on the brackets
a) Standard bracket.
b) Drive plate for specific bracket.
!
For optimal radio reception, the motor antenna should be kept
straight and should be positioned outside of headrail (if used).
2.2. WIRING
Precaution
To ensure electrical safety, this Class III motor must be powered by a «SELV» voltage source
(Safety Extra Low Voltage).
Attention
• Use power charger (recommended by Somfy) to charge the drive battery.
• To comply with shipping regulation, the battery level must be below 30% before shipping by air.
• Ensure battery is fully charged prior to commissioning.
!
While charging the battery, green drive LED blinks twice every 10 seconds
!
Drive LED lights Fixed on green when charger is plugged in and battery level is charged above 90%.
!
1
2
a b
Ø > 30 mm
L
1
2
a
b
