SOMFY ILMO 2 40 WT, Instructions Manual

Page: 18 / 24

16
EN
Copyright © 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
ILMO 2 40 WT
2. 3. COMMISSIONING

After having affixed the roller shutter to the roller tube,
check that when the roller shutter is in the lower end limit
position, the rigid link is correctly positioned and that the
first slat is vertically between the runners (as per F). If
necessary, adjust the number of slats used to improve the
position of the rigid link when the roller shutter is in the
lower end limit position.

Always refer to the manufacturer's size and weight charts
and fitting recommendations for the rigid links to select
those suited to the roller shutter used.
Use at least 2 rigid links to attach the roller shutter to the roller tube.
1)
Switch the power back on.
-
Press the "Up" button at the control point:
-
If the roller shutter rises, the wiring is correct and
commissioning is finished.
- If the roller shutter is lowered, go to the next step.
2)
Switch off the power.
-
Reverse the brown wire and the black wire connected to the
control point.
3)
Switch the power back on.
-
Press the "Up" button to check the direction of rotation.
2. 4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2. 4. 1. Questions concerning the ILMO 2 40 WT?
Problems Possible causes Solutions
The roller shutter is
turning in the wrong
direction.
The wiring is incorrect. Check the wiring and modify it if necessary.
The roller shutter is
not operational.
The wiring is incorrect. Check the wiring and modify it if necessary.
The drive is hot. Wait for the motor to cool down.
The control point is not compatible. Check for compatibility and replace the control point if
necessary.
The roller shutter
stops too soon.
The roller shutter is encountering friction
when it moves: friction along the runners and
case, interference between the roller tube and
the drive, etc.
Check the roller shutter installation and correct any
friction.
If the problem continues, restore the drive to its original
configuration.
The drive has been installed in a new roller
shutter.
Restore the drive to its original configuration, see the
section entitled "Restoring the original configuration".
The roller shutter
does not stop when it
reaches the lower end
limit position.
The mountings used are not correct. Check that the roller shutter is mounted to the roller tube
using rigid links.
The roller shutter
does not stop when it
reaches the upper end
limit position.
The roller shutter locking system in the upper
position is not correct.
Check that the roller shutter is fitted with end stops
screwed onto the last slat, fixed or removable stops
incorporated in the runners or an end slat acting as an
end stop.
F
F
1
2
3
ON
ON
OFF
OK
2
OK