![background image](http://html.mh-extra.com/html/somfy/control-box-3s-io/control-box-3s-io_installation-instructions-manual_1317477059.webp)
EN
Control Box 3S io
Copyright © 2015 Somfy SAS. All rights reserved
14
Code description
values
(bold = default)
Setting
completed Comments
p23
M1/M2 shift
when closing
1: minimum shift
at
10: maximum shift
Adjusted at the end of auto-
programming
1: Minimum shift ensuring the leaves do not cross.
Disabled if hinged gate with 1 "covering" leaf.
10: maximum shift corresponding to the complete movement of one leaf then the other
p24
M1/M2 shift
when opening
1: minimum shift
at
10: maximum shift
Adjusted at the end of auto-
programming
p25
M1 closing torque
limitation
1: minimum torque
at
10 (Axovia) or 20 (Ixengo): maximum
torque
Adjusted at the end of auto-
programming
IIf this parameter is modified, the installer must check that the limitation of forces complies
with appendix A of the standard EN12 453 or install a safety edge.
If the torque is too low, there may be erratic obstacle detection.
If the torque is too high, the installation may not comply with the standard.
p26
M1 opening torque
limitation
p27
M1 closing slowdown
torque limitation
p28
M1 opening
slowdown torque
limitation
p29
M2 closing torque
limitation
p30
M2 opening torque
limitation
p31
M2 closing slowdown
torque limitation
p32
M2 opening
slowdown torque
limitation
p37
Wired control inputs
0: complete cycle mode -
pedestrian cycle
1: opening mode - closing
0: terminal 30 input = complete cycle, terminal 32 input = pedestrian cycle
1: terminal 30 input = opening only, terminal 32 input = closing only
p39
Limit position
maintaining time
delay
0: no time delay
1: with time delay
This parameter is only available on Control Box 3S Ixengo io models.
p40
Coupling speed when
closing
1: slowest speed
at
4: fastest speed
default value: 2
If this parameter is modified, the installer must check that the limitation of forces complies
with appendix A of the standard EN12 453 or install a safety edge.
p41
Coupling speed when
opening
1: slowest speed
at
4: fastest speed
default value: 2