Beware!
There must be a fixed end stop to limit the door travel (upper stop, otherwise the drive
can run on during adjustment and the door mechanism may be damaged.
Advice:
Press program key lightly (e.g. with a biro)
In order to interrupt the adjustment procedure disconnect power plug. After the plug
has been re-inserted adjustment can begin again. Minimum gap between upper and
lower end stops is 30 cm. A smaller gap cannot be programmed.
■
Press the program key (b) for at least 2 seconds (biro) until the drive light goes out. (If
the drive light flashes the key was not pressed long enough). In this case withdraw plug
and re-insert. Start setting procedure from beginning)
■
Press operating key (a) briefly (1 second). Door drive runs in the "Door Open"
direction until the mechanical end stop and from there 5 cm back. It is possible to
correct this position by:
■
Press operating key and hold down until the required position is reached. On the next
press the drive will run in the opposite direction. When the desired position is reached:
■
The program key (b) must be pressed again for 2 secs until the drive light goes out.
Drive light goes out for 2 seconds and then lights up again, the upper end position is
now stored.
■
Press operating key (a) and hold down until the garage door is closed. Also the lower
end stop can be altered via the operating key as required, see above. To protect the
door mechanism adjust end stop to prevent door being pushed with excessive force.
■
Press program key (b) for 2 secs until the drive light goes out. The drive light will go
out for 2 seconds and come on again. The lower end stop is then stored.
■
Briefly press operating key (a) and wait until the door is completely open
■
Press operating key again and wait until the door is completely closed. The drive light
goes out and the adjustment procedure is complete.
If the test run is not successfully completed repeat entire procedure.
The test run is only complete if it has not been interrupted. During the test run the
garage door drive operates at full force and senses the required forces for opening and
closes. At every successful run the force is automatically re-adjusted (This is important
since, for example, in winter if the garage door runs more sluggishly).
Adjustment Instructions
SOMFY Garage Door Drive AXORN 65/85
14
1. Adjust upper
end stop
2. Adjust lower
end stop
3. Carry out test
run