Start up
Language chosen:
English
Next
Start up
Used network mode:
If not correct, change
before you continue!
Next
IB
Start up
Set clock
8:20
Next
Motor
Set down running time…
Set tilt time…
Set up running time…
1 sek
25 sek
25 sek
Set running time
Set tilting time
IMPORTANT:
If you change the network mode,
you must power the controller off and on.
Select language.
Give a manual up
command for zone 1.
Check cabling.
Check cabling.
Switch up and down
cable to motor/relay.
Give a manual
up command.
Repeat for zone 2.
Then done.
Give a manual down
command for zone 1.
Solar protection
going down?
Solar protection
going down?
No
No
No
Yes
Yes
Yes
Solar protection
going up?
7
J. poWEr up thE controllEr thE firSt tiME
k. chEck Motor DirEction
Enter the time (
down running time
) needed for the solar protection to move from fully up/in
position to the position where you want the solar protection to move to when e.g. sun and
timer functions are active.
If blinds are used also enter the time (
tilt time
) needed for the slats to move from fully
closed to the angle you want when the sun function is active. As a rule of thumb the time
up (up running time) should be double that of the down time (down running time).
To test your running and tilt times make sure that the solar protection is in the fully up/in
position and then give a manual down command.
l. SEt Motor running AnD tilting tiME.
UK
