SolBatt Home_User Manuel_B.00-EN
19/24
Information
Please note:
In the event that the SolBatt Home needs to be returned to us, please only send the device
in its original packaging.
You can also use the packaging from the replacement device that has been sent to you.
Ensure that the individual components are inserted correctly into the packaging so the
device is not damaged during transport.
If no original packaging is available, then pack it so it cannot be damaged during
transport.
You will be invoiced for any damage that occurs during transport due to defective
packaging.
14
First commissioning
14.1 Initial operation
Before starting a SolBatt Home, please make sure every component is installed correctly according to
the manual. When a SolBatt Home is connected to a SolHybrid, it will be detected and added to the
hybrid system automatically.
The SolHybird will implement “Conservation Charging” functionality for the first time and finish the
SOC (State of Charge) calibration by charging the SolBatt Home to full of energy.
After calibration finished, the system is now operational and the LEDs display will indicate different state
of the SolBatt Home, which mainly depends on the input of PV generators and the household load
consumption.
14.2 LEDs and push button
The user interface of a SolBatt Home consists of three LEDs (red, yellow, green) and one push button.
Red LED is labelled “ERROR”
Yellow LED is labelled “CHARGE”
Green LED is labelled ”POWER”
The button is labelled “OFF”
All the state of the SolBatt Home can be shown on the LEDs display board.
First commissioning