17
SLS-ENVR Series NVR V2.1 User Manual
SECTION 2: INSTALLATION AND SETUP
E-mail messages
In the Section E-mail messages, select the event for which the SLS-ENVR should send the e-mail message:
—
Send daily report about device health
- you will receive a message daily showing the SLS-ENVR device status. If
the messages are not being received, you should expect that something is wrong - perhaps an SLS-ENVR fault or network
failure.
—
Send e-mail when - Rescue mode is activated
—
Send e-mail when - Storage location event
- The SLS-ENVR informs you about a fault on a hard disk or the RAID
array.
9. In the Configuration Guide - Guide Complete window, click
Finish
.
After clicking Finish, the NVR will reset and a login window will open.
2.4 RAID Array Configuration utility
If the NVR is started for the first time after a new (un-configured) HDD was installed, the RAID Array Configuration utility will open.
1. If you have two HDDs installed in your NVR, select the RAID type you want to use from the drop-down lists.
NOTE
: For
information about RAID types implemented in the SLS-ENVR, refer to “RAID” in the website
en.Wikipedia.org
.
PRELIMINARY
Summary of Contents for SLS-ENVR Series
Page 6: ...vi NOTES PRELIMINARY...
