Solo 880-12, Instruction Manual

Page: 29 / 44

Power tool use
ENGLISH 27
Rotating direction of the cutting disc in the installed condition:
è
Chap. 5.1, page 16
Synthetic resin cutting discs must not be exposed to moisture. The water connection for wet cutting must
not be used when using synthetic resin cutting discs. Synthetic resin cutting discs must not be used in high
humidity or in rain. Only use synthetic resin cutting discs until the end of the best-before date imprinted on
the receptacle ring of the cutting disc.
The power tool's spindle is designed for cutting discs with an inner bore of 20 mm.
Cutting discs with a 1" inner bore must only be installed with the spindle adapter disc from the power tool's
delivery.
Installation of cutting discs with 1" inner bore:
è
Chap. 5.2, page 17
Cutting discs with other inner bores must not be installed!
New cutting discs must be tested for at least 60 seconds at the indicated maximum speed before the first
cutting process. No body parts must be located in the extended swivel range of the cutting disc.
û
The upper part of the cutting disc must not
be used for cutting!
ü
Only the lower part of the cutting disc must
be used for cutting!
Danger of injury from kickback!
Kickback results when the upper part of the cutting disc is used for cutting.
The power tool is pushed towards the user's head uncontrolled and under high energy.
•
Never cut with the upper area of the cutting disc!
•
Take special care at insertion into cutting areas already started!
Danger of injury from drawing along!
Drawing along results when the cutting point becomes more narrow (crack or tensioned work
piece).
The power tool is accelerated forwards uncontrolledly and under high energy.
•
Always perform cutting and repeated insertion into cutting points already started at the maximum speed.
•
Always support the work piece so that the cutting point is under tension so that the cutting disc is not
clamped when cutting any further.
•
When starting cutting, always carefully move the cutting disc to the work piece; do not apply it suddenly.
•
Never cut several work pieces at once!
•
Ensure that no other work piece is touched when cutting.
7.2 Permissible cutting area and danger from kickback or drawing along
ü
ok
û