Preparation for work - Installation ; Aplication
ENGLISH
4
2. Preparation for work – Installation
The blower may only be operated when fully
assembled.
Switch off the power tool engine before fitting (and
later removing) the attachment to/from the power
tool.
Fitting onto the shaft of the power tool:
•
Undo tension screw (1).
•
Release fixing pin (2) by pulling it out and
turning it.
•
Fit the shaft sections precisely onto the
inner/outer quadrant of the shafts.
Ensure that the hollow shaft in the lower shaft
section mates with the quadrant in the upper
section of the drive shaft. When assembling it
may be necessary to lightly twist the lower shaft
tube to and fro.
•
Release the fixing pin by turning and audibly
click into position in the shaft tube hole.
•
Thoroughly tighten clamping screws.
To separate the shaft sections:
•
Release the straining screw (1).
•
Pull out the fixing pin (2).
•
Pull the lower shaft tube (3) with gearbox from
the female coupling.
3. Application
Use the assembled leaf blower in accordance with
the illustration.
Always hold the assembled leaf blower securely
with both hands, and in such a way that the blower
head moves just above the ground. Use a carrying
strap.
Always point the blower away from your body and
never towards objects that could be damaged by
the air stream or material being blown by it.
