123
122
▲
■
RINSING THE MACHINE
We recommend letting the fully filled water tank run through the appliance to rinse
its inside once before using the appliance for the first time. This is done without
coffee powder.
Once the machine has reached standby mode (button surrounds by
POWER
,
MANUAL
,
and
light up constantly), carry out the following three steps:
1. Press the
button and let water run through the brewing group.
2. Set the
HOT WATER
dial (
B
) to
OPEN
and let hot water run through the hot
water outlet (
M
) for 30 seconds. Then turn the dial back to
CLOSED
.
3. Set the
STEAM
lever (
L
) to
OPEN
and let steam escape through the steam wand
(
N
) for 10 seconds. Set the steam lever back to the
CLOSED
position. Always
make sure that the steam wand is pointed towards the drip tray.
– Repeat these three steps until the water in the water tank is used up.
▲
▲
STARTING YOUR
SOLIS BARISTA TRIPLE HEAT
▲
■
FILLING THE WATER TANK
Through the tank lid, fill the water tank up to the MAX marking with cold, fresh tap
water. Never fill above the MAX marking.
Plug the power plug into a power outlet
Note:
Check the water level in the water tank before every use. Renew the water
daily. Fill the water tank with fresh, cold tap water before every use. Do not use any
distilled, carbonated or flavored water or other liquids.
▲
■
SWITCHING ON / HEATING UP THE ESPRESSO MACHINE
Press the
POWER
button to switch the machine on. The button surround of the
POWER
button flashes and the current temperature of the espresso boiler is shown
in the display.
Once the machine has reached the right operation temperature, the button sur-
rounds of the four buttons
POWER
,
MANUAL
,
and
light up constantly.
The appliance is now in standby mode and ready for use.
Notes:
The
,
and
CLEAN CYCLE
functions can not be used during the
heating up phase.
The appliance switches off completely if it is not used or no buttons are pressed for
more than 20 minutes (Automatic shutdown - power saving function).
