Model 464 Electronic Pump Control Unit User Guide
Page 6
Delete Settings
To delete the setting, use the left arrow key to highlight the delete icon and
press OK. After pressing OK, a prompt will be displayed to confirm the deletion.
Figure 2-10 Delete Saved Settings
W67 Farm 12
E89 Spill 2
A22 VOC 9
Saved Settings
W13 Landfill 34
Delete site
“W13 Landfill 34”?
Yes
No
4:59 Min
99%
Edit Settings
Select a particular setting by pressing the right arrow or OK.
Figure 2-11 Saved Setting Information
To edit site information, use the cursor keys to navigate the fields and modify
them using the +/- keys. Holding the +/- keys will cycle through letters and
numbers quickly. The OK button toggles between upper and lower case letters.
The “Site” field has a fixed length of 16 characters.
Use the +/- keys to change the drive and vent times. The maximum drive/vent
time is 999 seconds (16.65 minutes).
Use the +/- keys to change the pressure setting. The maximum pressure is
125 psi (861 KPa) or 250 psi (1724 KPa), depending on the Unit. Pressing OK
toggles between psi and KPa. The pressure is automatically converted to the
new units. The displayed pressure does not control the actual pressure, it is only
a reminder of the pressure to adjust externally.
When finished editing the site settings, use the cursor key to select “Save
Changes” or “Start” to start pumping without saving the changes. When “Stop”
is selected, a display will appear asking if you would like to save changes. User
settings are saved to non-volatile memory so that they will be retained if the
batteries are removed. A maximum of 99 user settings are supported.
Figure 2-12 Editing Saved Setting Information
Site: W13 Landfill 37
Drive:
5s Set Pressure:
Vent: 5s 25psi
Saved Settings [1 of 10]
Start
4:59 Min
99%
Site: W13 Landfill 3
7
Drive: 5s Set Pressure:
Vent: 5s 25psi
Saved Settings [1 of 10]
Start
Save Changes
4:59 Min
99%
NOTE
The maximum drive/vent time
is 999 seconds each and the
maximum pressure setting is 125
psi (861 KPa) or 250 psi (1724 KPa),
depending on the Unit.
NOTE
The displayed pressure does not
control the actual pressure, it is only
a reminder of the required output
pressure for that site.
NOTE
• 1 psi = 2.3 ft of water
• 1 KPa = 0.1 m of water
Summary of Contents for 464 Mk3
Page 1: ...Model 464 Mk3 Electronic Pump Control Unit User Guide September 24 2019 109652 Rev C...
Page 2: ......
Page 4: ......