Solidyne MB 2100, User Manual

Page: 8 / 22

2.1.3 Power source
The console can be operated without external power for 16
hours in continuous use due to its CMOS chipset
technology. It has a rechargeable Ni-Cd battery.
Console is provided with an external charger. The
switching charger is automatic: you can connect to any
outlet of 100 to 240 VAC.
When you connect the charger to the console, a red LED
(CHG) lights indicating the unit is recharging. THIS LED
WILL BE LIT WHILE THE UNIT IS CONNECTED TO THE
CHARGER, REGARDLESS OF THE UNIT IS ON OR
OFF.
The battery requires about 12 hours of connection to reach
its full charge. Above this value reduces the load current
may be permanently connected, if desired.
2.1.4 Program output (Bal Out)
The program output is balanced, monoaural, and uses a
TRS connector (Sleeve = Ground, Ring = signal [-] Tip =
signal [+] ) This output sends the signal from the program
mix, that is, the sum of the signals MIC-1, MIC-2, MIC-3
and MIC-4/LINE. The impedance of the device to connect
must be 10 KOhms or greater.
The signal passes through a compressor that
automatically manages the dynamic range, avoiding
differences of levels in the air or distortion on the
telephone line due to signal excess.
This output can connect to a portable DAT recorder or mini
disc to make recordings of high audio quality. You can also
send the signal to Studios using a VHF/UHF radio link to
transmit with studio quality (30-15.000 Hz)
2.1.5 Headphones output
There are two headphone outputs with 1/8” minijack. The
signal sent to the headphones is controlled from the knob
CUE, which select the source and adjust the volume
simultaneously. With CUE knob at center will not output
audio. Turning toward MIXER increase the audio level
Page 8 MB-2100 Portable mini-console SOLIDYNE