Solid State Logic AWS DELTA 916, Owner'S Manual, Page: 199 / 239

AWS
δ
elta Operator’s Manual Page 7-25
Automation
To display which controls are in each mode, press the Display softkey – the three Protection Modes will be shown in
the lower left-hand softkeys. Pressing one of these mode softkeys will cause the LEDs for all controls which are in that
mode become lit. (The fader status LED now lights to indicate when the fader’s current mode is selected, regardless of
whether or not that mode is Auto .) Pressing any individual controls (or in the case of the fader, the fader status button)
will cause them to be assigned to that mode, and the new mode will be shown on the Scribble Strip display.
For example,if the
Manual mode softkey is pressed, pressing a channel CUT switch will cause that switch to be put into
Manual mode, and the Scribble Strip for that channel will display CutC M . Note that channel faders are shown as FdrC,
monitor faders as FdrM, channel cut switches as CutC, monitor cuts switches as CutM.
Summary of fader status and FSM functions:
Note that the fader status buttons and LEDs and the FSM softkey fill a variety of functions:
– When in Mix Enabled, a red LED indicates Write, a green LED indicates Trim (see below) and no LEDs indicates
Replay. The FSM softkey and fader status buttons switch any faders and switches in Auto-mode between Write and
Replay (or, if Trim is active, between Trim and Replay).
– When the Protect screen is active, a red LED indicates Auto , a green LED indicates Safe and no LED indicates
Manual Protection mode. The FSM softkey and fader status buttons switch any faders and switches which have
been selected in the screen between Protection modes.
– When in Protect / Display , a lit LED (red for Auto or Manual , green for Safe ) indicates that the channel fader
is in the Protection mode which is currently displayed. The fader status buttons can be used to add faders to the
currently displayed mode.