1. Install the lock cylinder and door handle set:
a. Insert the key into the lock cylinder.
b.
Turn the key,
so the small peg on the cylinder aligns with the rest of the
cylinder body.
c. Insert the lock cylinder and tighten using the long bolt provided in the kit.
d. Match the door handle plates around the lock cylinder and fasten using
wood screws provided.
e. Insert both door handles with nylon gaskets. The handle with the
tightening bolt should be on the inside. Tighten the bolt while holding
handles pressed one towards another.
NOTE
. The door will not hold locked until you drill holes for the pin bolts at the top and
bottom of the left door panel. This, however,
should ONLY be done in 2-4 weeks
, after
your structure has settled and the door alignment has been addressed. See next page.
2. Install window handles
using wood crews
provided.
a. Insert the handle into the hole in the window.
b. Position the handle in the desired direction for the closed position – it can
look either way vertically or go from the center outwards horizontally.
c. Use wood screws to fasten it to the window frame. Pilot holes are not
necessary but can be helpful.
NOTE
. Packages containing window handles may include
2 bolts
that come pre-
packaged, although they
are not used in this assembly
. You may discard them.
STEP 17 - INSTALL DOOR & WINDOW HARDWARE
43
BRIGHTOLN 10 x 10 ft, 1
3
/
8
"