PRODUCT MANUAL
8-Zone RGB Remote Control
8-Z
one R
GB R
emot
e C
on
tr
ol
™
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
COLOR FADING PROGRAMS:
The LED Wizard 8 Zone remote control has 10 predefined color changing programs. You can
control the speed and brightness of any program.
Also, the unit uses smart ID technology to create an amazing color effect when more than
one receiver is used.
How to use the Color Effects programs.
1. First select the zones you want to control (1-8).
2. Press the “P+” or “P-” button to start a color changing program.
3. If you press the “P+” or “P-” button again you will pause the current color chase program.
4. If you press the “P+” button again, you will advance to the next program. If you press the
“P-” button again, you will go back to the last program.
Here’s how it works:
Program1 ---Pause---Program2----Pause---Program3---Pause---Program4---Pause---
Program5---Pause---Program6---Pause---Program7---Pause---Program8---Pause---Pro
-
gram9---Pause---Program10
Please Note: You can only navigate through 1 to 10 of the programs, when you
reach either end (1 or 10) it will not cycle back through the programs if you con-
tinue to press “P+” or “P-”.
Controlling Speed and Brightness of programs:
Once you selected the program of your choice, you can adjust the speed of the
program and brightness levels by using the Brightness and
speed controls.
1.
Use the S- and S+ on the remote to change and fine tune the speed at which the colors
change in any of the programs. There are 16 speed levels. The fastest speed is 4 seconds for
all the colors to cycle and the slowest speed is 256 seconds.
Changing Brightness:
2. Use the B- and B+ on the remote to change and fine-tune the brightness Levels of the
selected program.
Note: The B- and B+ also work when you have individual colors selected.
Press (P+ or P-)
Buttons to Move
through Programs
2, 3, 4
1.
1.
2.
Page 7
...continued on next page
EXTENDED CONFIGURATION
The 8 Zone controller can work with an unlimited number of receivers. For example, you can have
5 receivers working in zone 1, 10 receivers working in zone 2, and one receivers in zone 3. Also
you can have just one receiver on each zone. You can also create a chase effect of colors in just
one zone.
Example 1:
For example, if you installed 10 receivers controlled by the number“1” zone key on
the remote control, the 10 programmed receivers would initially react to button selection at the
same time, but as each reciever is a different distance the reaction time is different, and when
playing a color changing program, you would notice the lighting tied to each reciever would not
be in sync. To prevent this, a “master and slave” programming is needed so that all the receivers
will stay in sync with each other.
Example 2:
Imagine in zone 1 you want to have 10 receivers. You will have 1 Master and 9
Slaves. The master will transmit a synchronizing signal to all the slaves, so all the receivers work
in perfect timing when showing a color changing program is used.
