PRODUCT MANUAL
8-Zone RGB Remote Control
8-Z
one R
GB R
emot
e C
on
tr
ol
Toll Free: 866.592.3873
Email: [email protected]
www.SolidApollo.com
Installation
The 8 Zone RGB Remote Control and matching receivers can control up to 8 four channel RGB-W zones as a group or independently for
zones running from 12V to 36V DC. After the installation is complete, you can change the colors, play pre-programmed color changing
programs, or change brightness levels on each LED zone independently from 0% to 100% brightness.
Setting up the dimming system:
Tools Required:
3 AAA Batteries for Remote Control
Philips Screwdriver
Flat Head Screwdriver
Wire Stripper
To add power to the receiver, first make sure the power supply uses the correct voltage (12-24V DC). Then make sure the
power supply is not plugged in. Take the negative wire coming from the power supply, and using the Wire Stripper, strip
off approximately 1/4” of cover from the end of the wire. Twist the exposed metal wire to help make a secure connection.
This section will show you how to complete the wiring for one zone with a single receiver. To wire another zone, repeat the following
steps with another receiver.
1
Remove the white plastic end caps on both ends of the receiver using the Philips screwdriver. This will expose the green
wiring slot blocks.
2
...continued on next page
Page 2
Power
Source
(+)
(-)
LED
RGB-W
Light Fixture
(+)
(-)
(-)
(-)
(-)
