7
UNIT INTO SLEEVEINSTALLATION INSTRUCTIONS
Now, follow below steps to properly install the unit into the sleeve.
NOTE:
Sleeve assembly instruction is not included in this manual.
1. Attach(4) 4 1/2” x 3 1/2” x 1 1/2” Centering Support Blocks two on each side wall. Place in center of
side wall with the tapered end facing the opening .
2. Gently slide unit into sleeve.
3. Slide the unit completely to the rear to ensure a good seal, making sure the ground wire does not be-
come tangled.
4. Seal & Frame the unit as described in next page.
*Actual Sleeve may differ from image shown above.
1. Match the Plastic Grille on back of the sleeve.
2. Secure the Screw, Screw Washer, and Plastic Nut on each side of the sleeve shown as below:
Plastic Grille Installation
Tapered
End
Centering Support Block
Centering Support Block
Screw Washer
Plastic Nut
Plastic Grille
Sleeve
Screw
Once a compatible Solues Air sleeve (sold separately) is assembled, install the Plastic Grille(included)
on the back of the sleeve.
NOTE:
Plastic Grille could be substituted by Aluminum Grille, which is also included in the package.
