-Dry Mode
: When the unit is in Dry mode, the Dry mode light will turn on. Dry mode operates the
unit as an evaporative dehumidifier to remove excess moisture from the room. Use this feature when
there is excess humidity in the air.
-Auto Mode
: Press Mode button repeatedly to cycle to Auto mode. The unit will automatically run
between Cool and Fan based on current room temperature.
7)
Auto-on Delay Timer
- To program the Auto-on timer, press the
DELAY TIMER
button when the
unit is powered off. Press the ▲ or ▼ buttons to set the desired time (1-24 hours) for the unit to
automatically turn on.
Auto-off Delay Timer
- To program the Auto-off Timer , press the
DELAY
TIMER
button when the unit is powered on. Press the ▲ or ▼ buttons to set the desired timer (1-24
hours) for the unit to automatically turn off.
8)
Check Filter
- After the unit is on for 250 hours, the
CHECK FILTER
light will turn on to remind you
to clean the filter. Press the
FILTER RESET
button once the filter has been cleaned to turn the light
off.
9)
Sleep Mode
- Press the
SLEEP
button to enter the Sleep mode, the fan will run on low to keep fan
noise at a minimum. The temperature setting will gradually increase 2°F above the original set tem-
perature for each of first 2 hours. The unit will keep operating the same temperature until the sleep
mode is turned off.
10)
Energy Saver Mode
- When in Cool mode, Press
ENERGY SAVER
button to activate Energy
Saver mode, the Energy Saver light will turn on. Energy Saver mode will cycle the fan off and on
with the compressor to limit energy consumption. Use this feature when the room is unoccupied and
a greater range of room temperature is acceptable.
11)
Signal Receiver
- Point the remote control to the air conditioner when sending instruction to the unit.
OPERATING YOUR AIR CONDITIONER
