3
UNIT FEATURES CONTINUED
•
Unit Configuration
– There are many different configuration possibilities, through both dipswitches
and the digital keypad, that allow you to configure the unit for your exact application. See section on
unit configuration for more details. Following are the configuration selections that have not previouslybeen
mentioned:
•
_
F or
_
C
– The unit can display in either
_
F or
_
C
•
Indoor Temperature Sensor Biasing
– Optimize the room temperature sensor reading to your exact
application (one for cooling and another for heating)..
•
Emergency Heat (for Heat Pump Only)
– Disable the compressor during heating mode operation (heat
only with Electric Heat).
•
Display Setpoint OR Room Temperature
-- The unit can be configured to display the room
temperature OR setpoint only, during heating and cooling modes. See section on unit configuration for
more details.
•
Limit the Setpoint Range
-- The unit can be configured to limit the controlling setpoint range. The
display will always show the complete setpoint range, but the controlling setpoint will be limited to the
configuredminimumandmaximumsetpointselected. See section on unit configuration for more details.
•
Energy Management
– Sometimes known as
Front Desk Control,
an input is provided so that the
unit can be manually disabled from a different location. If the unit detects 24vac on this input, it will
automatically turn itself off. If no voltage is detected on the input, the unit will run normally.
Summary of Contents for SG-PTAC-09HPDA
Page 3: ......
