ASSEMBLY & INSTALLATION (CONT.)
Placing the Unit Inside a Normal Window
1. Place the air conditioner on the sill with the bottom
mounting rail against its back edge. Center the air con-
ditioner and close the window securely behind the top
mounting rail. The air conditioner should be slightly
tilted to the outside area. Use a level; about a 1/3 bub-
ble will be the correct case slant to the outside. (See
FIG.
2
& FIG.
3
)
2. Once the air conditioner is placed, extend both the left
and right accordion panels to the width of the window
.
4. Secure the left and right flanges on end bottom side
3.
Place the curtain lock between the curtain extensions
and the window sill, drive long screws through the
lock and into the sill as shown below.
Accordion Panel Installation
Now that you have installed the top rail, you can now install
the accordion panels on each side.
1. Place the air conditioner on a hard flat surface.
2. Locate the accordion panels in the box.
3.
Insert the side curtains into the upper and lower rails
of the air conditioner. Fasten the curtains to the unit
4. Slide the free end of the accordion panel into the side
panel of the air conditioner
.
Do this
for each side.
The
f
lange for securing the curtain into the window sill will
be
facing the room side when installed.
of the panel with long screws.
5. Drive long screws through upper frame holes into
sash seal between the glass and the window to pre-
6.
and lower sashes and secure it with
long
screws.
Attach the sash lock to the place between the upper
vent air and insects from getting into the room.
7. Cut the foam seal to the window width and insert the
with
short
screws as shown below.
FIG.
2
FIG.
3
window sash.
8. For added insulation, the insert strip can be inserted
between the air conditioner and window sill. This is
optional.
ach side use 2 long screws.
E
7
