21
GENERAL
MAINTENANCE
1.
Wipe down all areas in the sweat path with a damp cloth after each workout.
2.
If a squeak, thump, clicking or rough feeling develops the main cause is most likely
one of two reasons:
I.
The hardware was not sufficiently tightened during assembly. All bolts that
were installed during assembly need to be tightened as much as possible. It
may be necessary to use a larger wrench than the one provided if you cannot
tighten the bolts sufficiently. I cannot stress this point enough; 90% of calls to
the service department for noise issues can be traced to loose hardware.
II.
The crank arm nut needs to be retightened
III. If squeaks or other noises persist, check that the unit is properly leveled.
There are 2 leveling pads on the bottom of the rear stabilizer, use a 14mm
wrench (or adjustable wrench) to adjust the levelers.
MAINTENANCE MENU IN CONSOLE SOFTWARE
1. Press and hold the
Start
,
Stop
and
Enter
key at the same time, until the display
shows “Engineering Mode”. Press the
Enter
key.
2. You can now scroll through the menu using the
Up
and
Down
keys. Use the
Stop
key
to return to previous menu selection. The menu selections are:
A.
Key Test
B.
Display Test
C.
Functions
I.
Display Mode
- Turn Off to have the console power down automatically after 30
minutes of inactivity
II.
Pause Mode
- Turned On to allow 5 minutes of Pause, turn Off to Pause indefinitely
III.
ODO Reset
- Resets the Odometer reading to zero
IV.
Units
- Choose from English(Imperial) or Metric display readings
V.
Brake Test
- For testing the Brake function
D.
Security
E.
Factory Settings
- For Factory use only
F.
Exit
Summary of Contents for UPRIGHT
Page 22: ...22 EXPLODED VIEW DIAGRAM ...