TT8
TREADMILL
9
3
ASSEMBLY
STEP 3
HARDWARE
STEP 3
2.
Attach the left and right Upright Tubes (
5
&
4
) to the Main Frame
(
1
). Be careful installing the right upright so that the wire harness
doesn’t get pinched or cut.
Only hand-tighten all the bolts in
this step. The bolts will need to be completely tightened
after the console is installed.
Insert three Split Washers (
85
),
three Flat Washers (
102
), and three Button Head Socket Bolts
(
100
) through the brackets (
151
&
152
) and Console Mast Tubes
(
5
&
4
) and into the frame. Partially tighten with the M6 L Allen
Wrench (
105
). Attach two Curved Washers (
131
) and two Flat
Head Socket Bolts (
99
) to the front of each Console Mast Tube.
Partially tighten with the M5 Combination Allen Wrench &
Phillips Head Screw Driver (
104
).
4
ASSEMBLY
STEP 4
1.
Connect the lower Computer Cable (
33
) to the upper Computer
Cable (
31
), the remote S
peed Cable (
34
) to the upper Speed
Cable (
36-46
), and the remote Incline Cable (
35
) to the upper
Incline Cable (
36-47
).
Before attaching the hardware to Step 5, make sure the cables you just connected
don’t get pinched in between the steel tubing. If they do, this may cause issues that
prevent the treadmill from operating properly.
#85.
Ø10 x 2T
Split Washer (6 pcs)
#99.
5/16” x 3/4” Flat
Head Socket Bolt
(4 pcs)
#100.
3/8” x 2-1/4”
Button Head Socket
Bolt (6 pcs)
#131.
Ø8 x Ø23 x 1.5T
Curved Washer (4 pcs)
#102.
3/8” x 19 x 1.5T
Flat Washer (6 pcs)
