Front Panel
23
23
23
23
LED Arrangement
On
Lights on when Control Supply voltage is connected to
the starter.
Start
Lights on during start process, indicating that motor
supply voltage is ramping up.
Run
Lights on after completion of starting process to
indicate that motor is receiving full voltage.
S. Stop
Lights on during soft stop process to indicate that
motor supply voltage is ramping down.
Stop
Lights on when motor is stopped.
Test
Lights on when in “Test Mode” operation.
D. Adj.
Lights on when Dual Adjustment is in operation.
Fault
Lights on upon operation of any of the built-in
protection.
Keypad
Provides selection of the following
modes:
When Dip Switch 1 is in “On”, gray
zone shows list of maximized
parameters).
•
Display Only
•
Main Parameters
•
Start Parameters
•
Stop Parameters
•
Statistical Data
•
Dual-Adjustment Parameters
•
Fault Parameters
•
I/O Programming Parameters
•
Communication Parameters.
To select function within each mode.
To increase adjusted parameters.
Press momentarily or continuously to
select forward in statistical parameters.
To decrease adjusted parameters.
Press momentarily or continuously to
select revers in statistical parameters.
To save modified parameters.
To reset the starter after fault has
been removed, canceling the displayed
fault and allows restarting. Disconnect
Start signal to Enable reset.
Note:
Pressing Mode or Select continuously increases
parameters changing speed.
Mode
Select
Store
Reset
M
in
im
iz
e
M
ax
im
iz
e
