Solax S3121, Owner'S Manual

Page: 43 / 52

41
Battery and charging method
Scooter with two lithium batteries, long working time and service life. At
the same time equipped with charger, more convenient to use.
◇
The battery must be charged when it is used for the first time, and it is
recommended to charge the battery within 3 months from the date of purchase.
◇
If the battery is used for a long time, it must be removed after the battery is fully
charged and can not be stored in the vehicle.
Please follow the following steps to charge:
1. Turn off the valet key switch
(as shown in Figure 24).
2. Remove the AC power cord and
connect it to the charger connector.
3. Open the dust cover on the rear
of the scooter and insert the charger
connector into the charging hole
(as shown in Fig. 25).
4. Plug the AC power cord into the home power socket. At this time, the red indicator
light of the charger is on, indicating that it has entered the charging mode; the
orange light is on to indicate that the charging is in progress; the orange light turns
to green light to indicate that the charging is completed.
5. After charging, first pull out the AC power cord plug from the home power socket,
and then pull the charger connector out of the charging hole of the scooter, and
cover the dust cover at the rear of the scooter.
6. Arrange AC power cord and charger for next use.
Explain:
◇
The scooter has self-locking function when charging, which can prevent the
potential safety hazard caused by starting the scooter when charging.
◇
When you do not use the scooter for a long time, it is recommended that you take
the lithium battery fully charged and store it from the vehicle to extend the service
life of the lithium battery.
◇
When charging, if the indicator light of charger is not on / abnormal or cannot be
charged normally, please check whether the connection cable and plug are
connected normally. If the charging still can not be normal after troubleshooting,
please contact the local distribution agent or manufacturer for after-sales
consultation service.
Figure 24
Figure 25
After charging, the power switch must be turned off first, and then other plugs
can be pulled out, otherwise the service life of the charger will be affected.