SolaX Power X1-6.0-T-D, User Manual

Page: 20 / 24

f ) Power limits
User can set the power limit here, the setting value is from 0.00-1.00.
g) Grid
Usually end user do not need to set the grid parameters. All default value
have been set before leaving factory according to safety rules.
If need to reset, any changes should according to the requirement of local
grid.
﹦﹦﹦
Power Limits
﹦﹦﹦
>Proportion
0.00
﹦﹦﹦
Grid
﹦﹦﹦
>Vac Upper
000.0
Parameter Comment
Normally
Vac upper Voltage high protect
Vac lower Voltage low protect
Vac upper slow Voltage high slow protect
Vac lower slow Voltage low slow protect
Fac upper Frequency high protect
Fac lower Frequency low protect
Fac upper slow Frequency high slow protect
Fac lower slow Frequency low slow protect
Vac 10m avg 10 min voltage high protect
36
Operation Method Operation Method
P(u) Function
>Enable/Disable
e)P(u) Function
The device is suitable for Australia if the “Enable” is chosen.
>Enable<
h) DRM Function
User can choose whether using the DRM function or not.
﹦﹦﹦
DRM Function
﹦﹦﹦
>Mode Select
Disable
37
j) Reset error logs
User can reset the error log here. Press up or down button to select and
press “OK” to confirm.
﹦ ﹦ ﹦
>Reset
No
k) Start guide
This interface makes user set initial setting of the inverter again possible.
﹦ ﹦ ﹦
Start Guide
﹦ ﹦ ﹦
Reset Error logs
﹦ ﹦ ﹦
>Start
l) Reset energy
User can reset the energy record here. Press up or down button to select and
press “OK” to confirm.
﹦﹦﹦
Reset Energy
﹦﹦﹦
>Reset
No
﹦﹦﹦ ﹦﹦﹦