DKC400Y AC Sliding Gate Installation Manual www.solavis.com.au
Copyright © 2008 SOLAVIS
™
Doc: DKC400Y Installation Manual v1.1 page 22 of 22
Remote control does not work
The indicator light of remote
control does not light.
Check the batteries on your
remote control
Remote control is not suitable for
receiver.
After making sure the codes are
correct, erase remote controls and
then re-program the codes in the
device. See
Adding extra remote
controls (learning)
section.
Broken receiver board
Replace receiver board.
When you open the gate by using
button 1(button 2 or button 3)
which has been programmed, the
gate will stop in mid way or
reverse before reaching the fully
open position
The Force Adj. (VR1) (auto-
reverse function knob) is set too
low, making it extremely sensitive
Check the Force Adj. (VR1).
Adjust VR1 to decrease sensitivity.
Gate is obstructed.
Remove the obstruction.
The remote control operating
distance is too short.
Signals are shielded by the gate.
Link a new antenna (1~1.2m BVR
0.75mm
2
) to the old antenna. Then
fix the antenna on the wall
vertically, make sure the total
height from the top of antenna to
the ground is approx. 1.5m.
COPYRIGHT © 2009 SOLAVIS
WWW.SOLAVIS.COM.AU
2/28 ASSEMBLY DRIVE TULLAMARINE VICTORIA 3043
